CVE-2026-98530

kprobes: Fix permanent hang when flushing the kprobe optimizer

In the Linux kernel, the following vulnerability has been resolved: kprobes: Fix permanent hang when flushing the kprobe optimizer Writing 0 to /proc/sys/debug/kprobes-optimization while a kprobe is jump-optimized never returns. The writer sleeps in D state forever with kprobe_sysctl_mutex held, so any later read or write of that sysctl hangs as well. For example, with vfs_read+9 as an optimizable address in this build: # cd /sys/kernel/tracing # echo 'p:myprobe vfs_read+9' >> kprobe_events # echo 1 > events/kprobes/myprobe/enable # # wait until /sys/kernel/debug/kprobes/list shows [OPTIMIZED] # echo 0 > /proc/sys/debug/kprobes-optimization INFO: task sh:246 blocked for more than 10 seconds. Call Trace: <TASK> __schedule+0x1176/0x4f70 schedule+0xdc/0x2c0 schedule_timeout+0x17b/0x260 wait_for_completion+0x173/0x3c0 wait_for_kprobe_optimizer_locked+0xbc/0x130 proc_kprobes_optimization_handler+0x156/0x1b0 proc_sys_call_handler+0x324/0x490 vfs_write+0x52d/0xfe0 ksys_write+0xff/0x200 do_syscall_64+0x106/0x630 entry_SYSCALL_64_after_hwframe+0x77/0x7f </TASK> ... INFO: task cat:265 is blocked on a mutex likely owned by task sh:246. wait_for_kprobe_optimizer_locked() reinitializes optimizer_completion, asks the optimizer thread to flush and sleeps in wait_for_completion(). The thread drains the (un)optimizing lists, but calls complete() only if completion_done() is true, i.e. if the completion is already done, which never happens while someone waits. disarm_all_kprobes() and kprobe_trace_self_tests_init() wait the same way. Calling complete() unconditionally would not be enough: the waiter drops kprobe_mutex while it sleeps, and nothing else serializes the sysctl handler against the debugfs "enabled" file. A second flusher that still finds the lists non-empty, e.g. because a disabled probe is queued for unoptimizing, reinitializes the completion under the first: sysctl write debugfs "enabled" write unoptimize_all_kprobes() wait_for_kprobe_optimizer_locked() init_completion(c) mutex_unlock(&kprobe_mutex) wait_for_completion(c) disarm_all_kprobes() wait_for_kprobe_optimizer_locked() init_completion(c) // c->wait is reset, the first // waiter is off the queue mutex_unlock(&kprobe_mutex) wait_for_completion(c) kprobe_optimizer() complete(c) // wakes the debugfs writer only where c is &optimizer_completion. Lining up the two writes during an optimizer pass loses the sysctl writer this way. Replace the completion with a counter of optimizer passes, bumped at the end of each pass and signalled with wake_up_var_locked(), both under kprobe_mutex. A flusher samples the count and waits with wait_var_event_mutex(), which drops kprobe_mutex only while sleeping, so a new count means a whole pass ran in the meantime. Nothing is reinitialized, so several flushers can sleep in the wait at once.